fitting a security toolbox

fitting a security toolbox

Logged in as: Guest

Users viewing this topic: none

Printable Version

All Forums >> [Hummer Specific Discussions] >> H2 SUT & SUV >> fitting a security toolbox

Page: [1]

Message

<< Older Topic Newer Topic >>

fitting a security toolbox - 5/28/2008 3:12:56 PM

valletta

Posts: 2
Joined: 5/27/2008
Status: offline

I am looking to fit a 24"(long) by 18"x18" Highway Products tool box to my H2. I reckon the best place to bolt it to the floor might be in the same place where the spare wheel used to be mounted (next to the jump seat in the back).

Does anyone have any experience of this? Can I just drill four 1/4 inch holes thru the floor, fasten stainless steel bolts with big washers thru the box and then thru the floor tighten both ends and job done......or not!

Help and advice appreciated